Tips to Install Paint Protection Film for Your Car

All patterns are precisely cut to fit the entire area of your vehicle needing protection. Follow these simple steps for an accurate installation of your paint protection kit.

Steps

1

Clean area of vehicle to be protected. Use the water with rubbing alcohol to remove any dirt and wax. It is always best to wash the vehicle first.

2

Squeegee the water out from the center of the film outward. Work 3-4 inches at a time stretching when necessary. For areas or contours that need fast adhesion lift up the film and rinse using the alcohol water.

3

Use the paper towels to dry the edges of the film and prevent the water from seeping back under the film. Dry film completely and apply a coat of sealer.

Things You'll Need

Flexible squeegee

Two sprayers with solutions of soapy water and water with a little rubbing alcohol

Paper towels

Plexus polish or other non-petroleum polish or seal